Oriental motor ASD10A-K, Operating Manual, Page: 16 / 52

5 Installation
－ 16 －
• When installing from below the mounting plate
Fit the pilot section of the actuator into the pilot-receiving cutout.
Screw (M4)
Spring
washer
Mounting
hole
Mounting plate
Note
When the optional home-sensor set (sold separately) is used, the actuator
cannot be installed from below the mounting plate.
5.3 Securing the load to the output table
Install the load with screws using the load-mounting screw holes (six locations) in
the output table. The output table has two load-mounting pin holes of Ø5 mm
(Ø0.196 9 in.) in diameter and 6 mm (0.236 in.) in depth. These holes can be
combined with the positioning pins for accurate positioning of the load.
Bolt size Tightening torque
Effective depth of
bolt
Material of load
M3 1 N·m (142 oz-in) 8 mm (0.315 in.) Iron or Aluminum
Note Be sure the positioning pins are secured to the load. Driving the pins into
the output table may damage the bearing due to impact or an excessive
moment of inertia.
+ 0.012
0
+ 0.000 5
0