23
EN
When power is off, you will not be able to make or receive calls with the telephone.
After a power outage, place the handset in the base for about 20 seconds to reset the
digital security code.
POWER FAILURE
HEADSET JACK AND BELT CLIP
Headset connection
(Headset not included)
For hands free conversation, connect the headset (not
included) to the
HEADSET
jack. The handset earpiece and
microphone are disabled when the headset is connected.
Press
TALK
to answer or place a call while using the
headset.
Belt clip installation
•
Attach the belt clip by inserting the sides of the belt clip
into the slots.
•
Snap the ends of the belt clip into place.
•
Remove battery if storing the phone for over 30 days.
Make sure the telephone is off before you replace the battery.
1. Slide off the battery compartment cover.
2. Disconnect the battery plug from the jack in the compartment and remove the battery
pack.
3. Insert the new battery pack and connect the cord into the jack.
Note:
Please refer to the pictures on page 7, “Battery setup” for guide.
4. Put the battery compartment cover back on.
5. Place handset on the base to charge for 12 hours.
Note:
If the handset battery is removed for more than 5 minutes, the directory memory
and caller ID memory will be erased.
Charge the handset battery for 12 continuous hours prior to first use. The initial bat
tery charge is important for best performance.
Caution:
To reduce the risk of fire or personal injury, use a NI-MH 3.6 V, 600mAh battery.
086L004968-026
27/75
REV:1
