Reset Button
Power Button
Oracle Talari E1000 | Hardware Guide
Troubleshooting
The Reset and Power buttons are located behind the faceplate of the appliance, and
should only be used under the direction of Talari Support
. To access the Reset or
Power Buttons, the E1000 faceplate will need to be removed using the thumb screws:
Loosen the thumb screws fully. Fully loosened thumb screws should rebound slightly
when pressed towards the device and then released. Once fully loosened, gently use
the thumb screws to pull the removable faceplate away and down from the device.
Pivot the E1000 faceplate down on the built-in hinge (underneath the faceplate) as
shown above.
Appliance Troubleshooting Basics
Problem
Resolution
Cannot ping the E100 APN
appliance
Make sure the appliance has power. Confirm the device has
a Management IP address assigned. Verify the Management
port has link on the Talari and switch.
Ethernet port not forwarding traffic
Verify the switch has auto-negotiation enabled.
Verify the switch has the port enabled.
Confirm you connected to the correct port on the Talari.
Cannot access the Talari APNA Web
Console
Confirm you are using the correct IP address.
Confirm the management port of the E1000 APNA
is connected to a switch and there is activity.
2 6
