Oracle 3.2 TB NVMe, User Manual

Page: 18 / 48

Specifications
Electrical Specifications
The Oracle 3.2 TB NVMe SSD receives electrical power from the PCI E12 VDC and
+3.3 VDC power rails as shown in the following electrical specification table:
Specification 12 V Operating Characteristics 3.3 Vaux Operating Characteristics
Operating voltage range
†
12 V (+10%/-20%)
‡
3.3 V (+-9%)
*
Rise time (Max/Min) 50ms/1ms 50ms/1ms
Fall time (Max/Min)
•
5s/1ms 5s/1ms
Noise level 300 mV pp 10Hz – 100 KHz
50 mV pp 100KHz – 20 MHz
300 mV pp 10Hz – 100 KHz
50 mV pp 100KHz – 20 MHz
Power Consumption
5
12 V Active
6
■ Read 16W
■ Write 20W
Idle
7
: 7W
Off: 0W
Max 1 mA (at Read current)
Inrush Current 1.8 A 10 mA (1 ms rising time)
†
The components inside the SSD were designed to endure a range of voltage fluctuations, which might be induced by the host system,
‡
For 12 V operating voltage, the minimum allowable is 10.8 V and the maximum is13.2 V.
*
For 3.3 Vaux, the minimum allowable voltage is 2.97V and the maximum is 3.63V.
•
Fall time needs to be equal or better than minimum in order to guarantee full functionality of enhanced power loss management.
5
Power consumption was measured in the 12 V power pins (#P13~#P15) of the connector plug in SSD. The active and idle power is defined
as the highest averaged power value, which is the maximum RMS average value over 100 ms duration.
6
The measurement condition for active power is assumed for 100% sequential read or write.
7
The idle state is defined as the state that the host system can issue any commands into SSD at any time.
Related Information
■
“Product Overview” on page 9
■
“NVMe Drive Service Overview” on page 35
Reliability Specifications
The Oracle 3.2 TB NVMe SSD reliability specifications are shown in the following table:
18 Oracle 3.2 TB NVMe SSD User Guide • July 2016