2. The position of paper is determined by settings of the limiter located in the depth
of the working table. The limiter position can be changed by means of 2 screws
located underneath. The wire spine should be located in the direct proximity
of holes of the bound document (proper position on diagram J). In case of diagram
K, the working table is excessively advanced. In case of diagram L, the working
table is excessively retracted.
19
Operating manual of device Opus Sem i -automatic Wire Closer
2. The position of paper is determined by settings of the limiter located in the depth of the working table. The
limiter position can be changed by means of 2 screws located underneath. The wire backbone should be
located in the direct proximity of holes of the bound document (proper position on diagram J). In case of
diagram K, the working table is excessively advanced. In case of diagram L, the working table is excessively
retracted.
8.5. Calendar hangers feeder
The feeder must be manually refilled with hangers of maximum length of 355 mm.
19
Operating manual of device Opus Sem i -automatic Wire Closer
2. The position of paper is determined by settings of the limiter located in the depth of the working table. The
limiter position can be changed by means of 2 screws located underneath. The wire backbone should be
located in the direct proximity of holes of the bound document (proper position on diagram J). In case of
diagram K, the working table is excessively advanced. In case of diagram L, the working table is excessively
retracted.
8.5. Calendar hangers feeder
The feeder must be manually refilled with hangers of maximum length of 355 mm.
Calendar hangers feeder
The feeder must be manually refilled with hangers of maximum length of 355 mm.
30
