optris PI 400 LW, Operator'S Manual

Page: 37 / 52

optris PI LightWeight Kit
– E2013-04-B
35
Ethernet Network Communication
Please connect your imager with the supplied USB connection cable with the NetBox. Please connect the
Ethernet connection of the NetBox with a network or internet (via a router e.g.). Now connect the power
supply to the NetBox and to the mains. The NetBox will start to boot the system and should be ready to use
after 2-3 minutes.
You can check the status with the LEDs. At proper functioning now L1 and L5 should light up.
Ethernet network connection/ NetBox LW powered via power supply
If you use a PoE injector the power supply for the NetBox is not needed. In this case please connect the PoE
injector as shown in the drawing below. At proper functioning now L1, L2 and L5 should light up.