optris CSlaser 2MH, Operator'S Manual

Page: 34 / 50

-
34
-
For a digital communication the optional USB programming kit is
required. Please connect each wire of the USB adapter cable with
the same coloured wire of the sensor cable by using the terminal
block. Press with a screw driver as shown in the picture to loose a
contact.
Alternatively the USB cable can also be connected directly on the
sensor
[►5.1 Cable Connections]
.
The sensor is offering two ways of digital communication:

bidirectional communication (sending and receiving data)

unidirectional communication (burst mode
– the sensor is sending data only)
5.4 Digital and Analog Mode combined
The CSlaser are able to work in the digital mode and simultaneously as analog device (4-20 mA).
In this case the sensor will be powered by the USB interface (5 V).