Optoma ZU720T, User Manual

Page: 42 / 76

English 42
USING THE PROJECTOR
¾
Blend Gamma : Set the blend gamma. Options include: 1.8, 2.0, 2.2 (default), 2.4, and 2.6.
‡ Reset : Return the factory default settings for geometric correction settings.
Signal
Adjust the signal options.
‡ Automatic : Configure automatically the signal (the frequency and phase items are grayed out). If
automatic is disabled, the frequency and phase items will appear for tuning and saving the settings.
‡ Frequency : Change the display data frequency to match the frequency of your computer’s graphic
card. Use this function only if the image appears to flicker vertically.
‡ Phase : Synchronize the signal timing of the display with the graphic card. If the image appears to be
unstable or flickers, use this function to correct it.
‡ H. Position : Adjust the horizontal positioning of the image.
‡ V. Position : Adjust the vertical positioning of the image.
Note:
This menu is only available if the input source is RGB/Component.
PIP/PBP
Display an image with two sources in PIP mode or PBP mode.
Note:
PIP/PBP function does not support 3D.
‡
Screen
: Toggle between displaying two sources at once (Main and PIP/PBP images) or one source
only.
¾
None : Display image from the main source only.
¾
PIP : Display images from two sources by separating the screen into two parts. One source is
displayed on the main screen and another source is displayed in an inset window.
¾
PBP : Display images from two sources by separating the screen into half. One source is
displayed on the left side of the screen and the other source on the right side of the screen.
‡
PIP Location
: Set the PIP location from top left, top right, bottom top, and bottom right.
‡ PBP Location : Set the PBP location from main left, main top, main right, and main bottom.
‡ Size : Set the PIP sub source size from Large, Medium, and Small.
‡ Main Source : Select an active input to be used as the main image. The available inputs include HDMI
1, HDMI 2, VGA, HDBaseT, USB, and Home.
‡
Sub Source
: Select an active input to be used as the sub image. The available inputs include HDMI 1,
HDMI 2, VGA, HDBaseT, USB, and Home.
‡ Swap : Change the location of the PIP/PBP, and the PIP/PBP to main image. Swapping is available
only when PIP/PBP is enabled.
Note:
A) PIP/PBP compatibility table as described below:
PIP/PBP
Main
VGA
HDMI 2 HDMI 1
HDBaseT USB
v1.4 v1.4 v2.0
Sub
VGA - - - - - -
HDMI 2 v1.4 v - v v v v
HDMI 1
v1.4 v v - - v v
v2.0 - - - - - -
HDBaseT v v v v - v
USB - - - - - -
1. Flashing lines may occur if the bandwidth of both inputs are too high, please try to reduce the
resolution.