Safety
Version 1.0.1 - 2020-08-10
5
Translation of original instruction
GU30S
EN
GU30S
_GB
.f
m
the inspection and maintenance instructions are observed.
WARNING!
Severe injuries due to non-intended use.
It is forbidden to make any modifications or alternations to the operating parameters
values of the grinding machine. They could pose an accident hazard to persons and
cause damage to the grinding machine.
ATTENTION!
If the grinding machine is not used as intended or if the safety directives or the operating
instructions are ignored the liability of the manufacturer for any damages to personnel
or objects resulting hereof is excluded and the claim under guarantee is becoming null
and void!
1.3
Reasonably foreseeable misuse
Any other use other than that specified under "Intended use" or any use beyond the described
use shall be deemed as non-intended use and is not permissible.
Any other use has to be discussed with the manufacturer.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before first commissioning.
Operators must be qualified.
1.3.1
Avoiding misuse
WARNING!
Risk of injury caused by flying workpieces.
Ensure the gap between the grinding wheel and bearing surface is as small as possible and
readjust the support surface immediately if the distance is too big. The distance from the sup-
porting surface to the grinding wheel may not be less than 2 mm. However, the distance may
be greater if the grinding process and the material used require this for security reasons.
If the support surface can no longer be adjusted, the grinding wheel must be replaced.
The direction of rotation of the grinding machine must be in the direction of the contact surface
or the stop on belt grinder device. If the phase sequence is not used correctly, it is possible to
operate the grinding machine in the wrong direction of rotation.
Pay attention to the current direction of rotation of the grinding machine to prevent the spin-up
of workpieces at the start of grinding.
We expressly point out that the guarantee will expire, if any constructive, technical or proce-
dural changes are not performed by the company Optimum Maschinen Germany GmbH.
WARNING!
Risk of injury caused by flying workpieces. Injuries caused by sharp-edged workpieces.
Injuries caused by hot workpieces. Wear protective gloves and goggles. For certain
materials it may be necessary to wear face protection instead of safety glasses.
Make sure that the support surface on the grinder and the belt sander for the workpiece are
firmly clamped.
1.4
Possible dangers caused by the grinding machine
The grinding machine was built using state-of-the-art technology. Nevertheless, there is a resid-
ual risk, as the grinding machine operates with
high speeds,
rotating parts,
