OPTICON
User's manual
PHL-7000 series
3-4
9 sec
9 seconds
Indefinitely Single
read mode : reader will stay on
until a bar code is read.
Multiple read mode : reader will stay on
until power is recycled (not
recommended)
X1
No multiplication of read time (default)
X10
Read time * 10
Version
Information field which shows the bar code readers
firmware version.
RBAV01xx is used for 1D laser module.
FL23Jxx is used for 2D CMOS module.
If no version is displayed the bar code reader is not
found.
Note xx can have a value between 01 and 99.
Table 3-2
Basic TAB description
3.2.1.2 Code Configure TAB
In the Code Configure tab the bar code symbologies can be enabled or disabled.
It is strongly recommended to select only the required code. Advantages of selecting the
required codes are :
•
faster
reading,
•
no accidental scanning of unwanted bar codes,
•
reduced probability of reading errors which can not be prevented completely, because of the
limited security of some bar code types.
Bar code specific options can not be selected in this version of the Bar Code Settings tool.
In case bar code specific options are required, refer to Opticon’s Universal Menu Book, chapter
3 and lookup the serial command sequence, and enter this commands sequence in Bar Code
Settings tool’s “Advanced” TAB.