O P T I O N A L M O D U L E I N S T A L L A T I O N
9
Step 2
: Plug one end of the cable bundle (H01) into the corresponding socket on the main board.
Pay attention to identify the correct direction, align the plug properly and firmly plug it in.
Step 3
: Plug one end of the ribbon cable (H02) into the corresponding socket on the main board.
Pay attention to identify the correct direction and align the plug properly. The plug should be locked
into the socket once it is firmly plugged in.
Step 4
: Install the board riser (H03) into the screw hole on the bottom plate located near the center
of the main board. Tighten with a hex socket screwdriver.
