R E F E R E N C E S
80
REFERENCES
Useful Notes
•
In order to prolong the service life of your player, it is recommended to wait at least 30 seconds
before you turn it on again after switching it off.
•
Remove disc and turn power off after operation.
•
Some functions of the player may not be applicable to certain discs.
•
Some discs with special features may not be fully supported by the player. This is not a malfunction
of the unit.
•
In case of player malfunction, please turn it off, wait for 30 seconds and turn it back on. If the
problem still exists, please follow the troubleshooting instructions or contact an OPPO service
center.
Troubleshooting
Use this chart to resolve general operational problems. If there are any problems that you cannot resolve,
please contact your OPPO service center.
Symptom
Possible Cause
Solution
Reference
Page
Audio cable is not properly
Connected
Check audio cable, and then reconnect if necessary.
10 - 17
Mute is activated
Press the MUTE button to cancel the mute.
31
Volume is too low
Press the VOL + button to increase the volume to 100.
31
SACD is played and the audio
connection is coaxial or optical
digital audio
This is not supported due to copyright restrictions of
SACD. Please use the analog or HDMI audio output.
Alternatively, you may set SACD Priority to CD mode
and the player will play the CD layer.
16, 51
No sound
DVD-Audio is played and the
audio connection is coaxial or
optical digital audio
This is not supported due to copyright restrictions of
DVD-Audio. Please use the analog or HDMI audio
output. Alternatively, you may switch to the DVD-
Video playback mode.
16, 51
Video cable is not properly
connected
Check video cable; reconnect if necessary.
10 – 11
TV input is not correctly
selected
Select the input to which the player is connected.
“Pure Audio” mode engaged
Press the PURE button to cancel this mode.
42
Video output format is not
support by the TV
Select a proper output resolution that is supported by
your TV.
34
No picture
Video system is not supported
by the TV
When playback is completely stopped, press and hold
the P/N button or set the correct TV System in the
Setup Menu.
34, 54
Video system is not supported
by the TV
When playback is completely stopped, press and hold
the P/N button or set the correct TV System in the
Setup Menu.
34, 54
Saturation set too low
Check the saturation setting on TV and player.
55
Loose or damaged component
video cables
If using component output, check that the three cables
are all properly plugged in and not damaged. Make
sure the Colour of the plugs match the jacks on both
ends.
13
No Colour
Incorrect video output port
If using composite video output, check that the cable is
not incorrectly plugged into a component video jack.
10
Incorrect Colour space setting
If using HDMI for video output, check the Colour space
setting on the TV and player.
53
Incorrect Colour
Incorrect component video
cable connection
If using component video output, check the three
component video cables to make sure the signals
match on both ends
13
