Opop Biopel MINI, Installation And Operation Instructions Manual

Page: 21 / 64

Biopel MINI - Installation and Operation Instructions
21
This is the list of all functions inside the control unit which are connected with each output in the external socket. Use this list
for better orientation of accessories setup and activation. Similarly, the source of an alarm message can be easily traced from
this list if a function has been activated but the associated sensor is not connected.

RJR5 - Installation menu:

Ethernet module.

RS1 and 2 - Installation menu:

Lambda

Room thermostat

Additional valve 1 and 2

GSM module

Cascade controller.

Additional sensor 4 and 3 - Installation menu:

Future use

Additional sensor 2 and 1 - Installation menu:

Additional pump

Buffer tank parameters

Built-in valve 1,2 - Selection of CH sensor

Solar contact - Installation menu:

Solar control.

Room thermostat 1 and 2 - Installation menu:

Room thermostat - Standard regulator 1 and 2

Built-in valve 1,2 - Room thermostat - Thermostat standard.

Outdoor sensor - Installation menu:

Built-in valve 1 and 2 - Equitherm control

Outdoor temperature correction

Firing up blocked

Return water sensor - Installation menu:

Built-in valve 1 and 2 - Return flow protection

Valve sensor 2 and 1 - Installation menu:

Built-in valve 1 and 2

DHW sensor - Main settings:

Operating mode - DHW priority or Parallel pumps or Summer mode
– Service Menu:

Disinfection - Disinfection Temperature

Priority Temperature

DHW Hysteresis

Flue gas temperature sensor - Service menu:

Max. flue gas temperature

Safety sensor Termik - No associated function

CH sensor - Main settings:

CH temperature setpoint

Boiler weekly programme

Operating modes - House heating
– Installation menu:

Built-in valve 1,2 - Boiler protection
– Service Menu:

CH pump emergency activation

Boiler alarm temperature

Pump switch-on temperature

Min. boiler temperature

Boiler Hysteresis

Internal feeder temperature sensor - Service menu:

Feeder Alarm temperature

Photosensor - Service menu:

Pellet settings - Ignition parameters - Firing-up brightness

Pellet settings - Operating parameters - Operation control

Mixing valve 2 and 1 - Installation menu:

Built-in valve 1,2

Additional pump - Installation menu:

Additional pump