Onset
Computer
Corporation
User’s Guide
- 29 -
HOBO U30 Station/RC
I n s t a l l i n g W e a t h e r p r o o f C a b l e C h a n n e l s
NOTE
: If you are doing a pre-deployment test setup, you do not need to install the weatherproof cable
channel for the sensor cables if you are going to disconnect the sensor for transportation to the field.
Guidelines
•
All cables and wires should be routed through the cable access opening at this point.
•
If you are using the Smart Sensor expander board, make sure those cables are routed through the
secondary cable access opening.
Steps
1.
Grease the Cable Channel.
Apply a small amount of silicone grease (about the size of a pea) onto your fingertip and then work
a light coating into the top, bottom, and two ends (the sides with no holes) of the rubber cable
channel. Also put a light coating on the inside of the two halves of the cable channel.
Figure 9:
Grease Cable Channel
Summary of Contents for hobo u30
Page 1: ......
