Onset
Computer
Corporation
User’s Guide
- 83 -
HOBO U30 Station/RC
I n s t a l l i n g t h e E x p a n d e r B o a r d
Before You Begin
If you have not already done so, open the Secondary Cable Slot (see page 81).
Steps
1.
Insert a self-tapping screw (supplied) into each end of the expander.
2.
Lower expander onto the two standoffs near the bottom of the case.
3.
Screw expander into place.
Alternate Method
: Place expander (without the screws) onto the standoffs. Apply a small amount of
clear grease (the grease supplied with this kit can be used) at the end of the screwdriver to hold screws
while lowering them into place.
NOTE
: The contacts of the expander jacks should be nearest to the bottom of case as shown below.
CAUTION
: Be careful not to trap the battery cable behind the board.
Figure 19:
Expander Board
Summary of Contents for hobo u30
Page 1: ......
