ONOSOKKI TS-3200A, Instruction Manual

Page: 53 / 171

3-25
• CAPACITY
The value specified here becomes the full-scale value of the analog output. The position of the decimal
point of the display changes according to the input value of CAPACITY.
• Input range
10 to 99999
• UNIT (unit)
The unit specified here becomes the unit for the measurement display.
r/min, r/s, Hz
• LOW
When a certain rpm or lower rpm values do not need to be measured and displayed, the value is set as
LOW.
When an rpm below the setting continues, both the display and analog output become almost zero.
When SIGNAL is 0:Int Revo, the minimum input value of LOW shall be 1.
Set LOW after CAPACITY, P/R, and RATIO have been set.
• P/R
Enter the number of pulses oscillated by the rotary encoder for each rotation of the shaft of the rotary
encoder.
When using a gear, enter the number of teeth; when an encoder is used, enter the number of oscillations.
• SIGNAL
Select the rotary encoder to be used.
0:Int Revo: When using SIG2 of the torque detector as a rotation signal
Note: When the motor supplied with the torque detector is rotating, the display values becomes
greater by the rpm.
1: Revo1: When the MP-910 is used (input from the REVO1 connector on the rear panel)
2:Revo2 (Single):
When the MP-981 is used (input from the REVO2 connector on the rear panel)
3:Revo2: (Double): When a 2-phase type encoder is used (input from the REVO2 connector on the
rear panel)
When
0:Int Revo
is selected, P/R performed by the (DETECTOR) and (TORQUE) settings becomes
effective.
• RATIO
Refer to 3.6.1, "When Rpm Is Not Detected Directly from Rotating Shaft (Input of RATIO)."
Input value of CAPACITY
10000 to 99999
1000 to 9999
100 to 999
10 to 99
Decimal point position of measurement display
00000
0000.0
000.00
00.000
1
1.0
0.01
0.001
Minimum input value of LOW
3. Basic Operations