|
11
> Settings
|
Setting Item
Default Value
Setting Details
Height 2 Speaker Rear High
Set the speaker type if height speakers are
connected to the HEIGHT 2 terminals. Select
"Front High", "Top Front", "Top Middle", "Top
Rear", "Rear High", "Dolby Speaker (Front)",
"Dolby Speaker (Surr)", or "Dolby Speaker (Back)"
according to the type and layout of the connected
speakers. However, the options selectable for the
"Height 1 Speaker" the are as follows.
If "Height 1 Speaker" is set to "Front High": Select
from "Top Middle", "Top Rear", "Rear High", "Dolby
Speaker (Surr)", or "Dolby Speaker (Back)".
If "Height 1 Speaker" is set to "Top Front" or "Dolby
Speaker (Front)": Select from "Top Rear", "Rear
High", "Dolby Speaker (Surr)", or "Dolby Speaker
(Back)".
If "Height 1 Speaker" is set to "Top Middle": Fixed
to "Rear High".
•
"Dolby Speaker (Surr)" and "Dolby Speaker
(Back)" can only be selected when surround
speakers or surround back speakers are being
used, respectively. You can check speakers
that you are using on the figure displayed in
"Speaker Channels".
•
If an item cannot be selected even though
connection is correct, check that the settings
in "Speaker Channels" matches the number of
connected channels.
Zone Speaker
No
Set the connection of speakers to Zone 2 or Zone
3 speaker terminals.
"Zone 2": When speakers are connected only to
Zone 2 speaker terminals
"Zone 2/Zone 3": When speakers are connected to
both Zone 2 and Zone 3 speaker terminals
•
"Zone 2/Zone 3" cannot be selected when
surround back speakers and height speakers
are being used.
"No": When speakers are not connected to either
speaker terminals
•
This item will be set to "No" when two sets of
height speakers are being used.
Setting Item
Default Value
Setting Details
Bi-Amp
No
Set whether the front speakers are bi-amp
connected.
"No": When front speakers are not bi-amp
connected
"Yes": When front speakers are bi-amp connected
•
In any of the following cases, this item will be
set to "No":
– When two sets of height speakers are being
used
– When "Zone Speaker" is set to "Zone 2/Zone
3"
– When height speakers and ZONE speakers
are being used at the same time.
Summary of Contents for TX-RZ1100
Page 35: ...35...