Onkyo HT-RC560, Owner'S Manual

Page: 58 / 140

Advanced Operations
En-58
Operating
procedure
(
➔
page 52 )
Note
• If the “ Front High ” settings is set to “ None ” (
➔
page 56 ),
this setting cannot be selected.
• If the “ Powered Zone 2 ” setting is set to “ Yes ” and Zone 2
is turned on, this setting cannot be selected.
■
Dolby EX
`
Auto :
If the source signal contains a Dolby EX flag, the
Dolby EX listening mode is used.
`
Manual :
You can select any available listening mode.
This setting determines how Dolby EX encoded
signals are handled. This setting is unavailable if no
surround back speakers are connected. This setting
is effective with Dolby Digital, Dolby Digital Plus and
Dolby TrueHD only.
Note
• If the “ Surround Back ” setting is set to “ None ”
(
➔
page 56 ), this setting cannot be selected.
• If the “ Powered Zone 2 ” setting is set to “ Yes ” and Zone 2
is turned on, this setting cannot be selected.
• If the “ Front High ” setting is enabled (
➔
page 56 ), this
setting is fixed to “ Manual ”.
■
TrueHD Loudness Management
`
Off
`
On
This setting specifies whether or not to apply the Late
Night processing on a Dolby TrueHD source.
Note
• When this setting is set to “ Off ”, the Late Night function for
Dolby TrueHD sources is automatically fixed to “ Off ”.
DTS
■
Neo:6 Music
Center Image
`
0 to 2 to 5
The DTS Neo:6 Music listening mode creates 6-
channel surround sound from 2-channel stereo
sources. With this setting, you can specify by how
much the front left and right channel output is
attenuated in order to create the center channel.
Changing the value from “
0 ” to “ 5 ” will spread the
sound of the center channel to left and right
(outwards).
Theater-Dimensional
■
Listening Angle
`
Wide :
Select if the listening angle is greater than 30
degrees.
`
Narrow :
Select if the listening angle is less than 30
degrees.
With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of
the front left and right speakers relative to the
listening position. Ideally, the front left and right
speakers should be equidistant from the listening
position and at an angle close to one of the two
available settings.
Note
• For best results, we recommend setting “
Narrow
” to 20°
and “ Wide ” to 40°.
Items can be set individually for each input selector.
Press the input selector buttons to select an input
source.
Audyssey ®
The tone for each speaker is set automatically by
Audyssey MultEQ
® Room Correction and Speaker
Setup. To enable the following settings, you must first
perform the Room Correction and Speaker Setup
(
➔
page 24 ).
• These technologies cannot be used when a pair of
headphones is connected.
■
Audyssey
`
Off
`
Movie :
Select this setting for movie material.
The
Audyssey indicator will light.
`
Music :
Select this setting for music material.
The
Audyssey indicator will light.
Note
• When “ Audyssey Quick Start ” has been used for
measurement, “ Audyssey ” cannot be selected.
• Audyssey equalizing does not work with DSD sources.
Front left speaker Front right speaker
Listening angle: 30°
4. Source Setup