After Sales Support
TEL: 1300 886 649
6
10. Reconnect the cable to the vehicle battery’s negative (-) terminal.
Then replace the outer trim ring and install the unit’s front panel
(see the steps of ‘to install the front panel’).
Removing the unit:
1. Make sure the ignition is turned off, and then disconnect the cable
from the vehicle battery’s negative (-) terminal.
2. Remove the metal strap attached to the back of the unit (if attached).
3. Press the release button to remove the front panel.
4. Lift the top of the outer trim ring then pull it out to remove it.
5. Insert both of the supplied keys into the slots at the middle left and
right sides of the unit then pull the unit out of the dashboard.
2. DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan, Toyota, follow this mounting instruction.
Use the screw holes marked T (Toyota), N (Nissan) located on both
sides of the unit to fasten the unit to
the factory radio mounting brackets
supplied with your vehicle. Fasten the
unit to the factory radio mounting
brackets. Align the screw holes on
the bracket with the screw holes on
the unit, and then tighten the screws
(5x5mm) on each side.
NOTE: The outer trim ring, sleeve
and the metal strap are not used for
method B installation.
Installation