Oneida Air Systems Supercell XSK000014, Owner'S Manual

Page: 13 / 32

oneida-air.com 11
Assembly Instructions (Continued)
8
Lift the Wall Bracket (F) up and over the
fasteners so that the washer is on the inside of
the bracket. Slide the Wall Bracket (F) down
so that the fastener is snugly inside the smaller
section of each keyhole [FIG. 8].
9
Tighten these four fasteners to secure the Wall
Bracket (F) to the wall [FIG. 9].
Note: If installing over drywall, avoid
overtightening as it may damage the wall.
10
Fasten the Rear Support Brace (G13) to the
wall using your own suitable hardware [FIG.
10]. Refer to the previously marked line for
the suitable mounting location of this Brace.
Note: This hardware is not load bearing and
only needs to connect the brace to the wall to
add additional support to the system during
operation. Fasten through at least one hole.
FIG. 8
FIG. 10
FIG. 9
W
all