Oneida Air Systems Supercell XSK000014, Owner'S Manual

Page: 10 / 32

Oneida Air Systems, Inc. 8
Assembly Instructions
1
Installing the Bin Gasket (G23) onto the Wall
Bracket (F).
a. Turn the Wall Bracket (F) upside down
[FIG. 1a].
b. Lay out the four Bin Gasket segments
(G23). DO NOT REMOVE THE BACKER
TAPE [FIG. 1b].
c. Arrange the Bin Gasket segments (G23)
in a circle with the ends interlocking and
aligning to the rounded front edge of the
wall bracket [FIG. 1c].
d. Carefully mark a circle around the inside
of the arranged Bin Gasket segments
(G23) with a marker to create a reference
line [FIG. 1d].
e. Peel the backer tape off of the Bin Gasket
segments (G23) and adhere them to the
Wall Bracket (F), lining them up with your
reference line [FIG. 1e].
Note: Press each gasket piece firmly onto the
bracket to ensure a long-lasting, airtight seal.
FIG. 1a FIG. 1b
FIG. 1c
FIG. 1e
FIG. 1d
You will need the following tools:
WALL MOUNTING BRACKET CYCLONE BODY DRUM LATCHES
Stud Finder Light Adhesive Tape 7/16" Wrench 3/8" Wrench
Tack / Center Punch / Nail Tape Measure / Ruler 7/16" Socket Wrench #2 Phillips-Head Screw Driver
Wall Mounting Fasteners * Level 1/2" Wrench
Power Drill Pencil / Marker 1/2" Socket Wrench
Drill Bit (for your wall fastener)
*You will need to supply your own wall mounting hardware. Use appropriate fasteners for the wall type you are
installing your system onto (e.g. lag bolts, drywall anchors, etc.).
G23
F