Page 11
For technical questions, please call 1-888-866-5797.
Item 63781
Roof Cover Installation
1. Lay the Roof Cover (15) on the ground next to the frame. Make sure that the edges with black straps are
alongside the Door/Back Covers (16, 17) with the fabric tubes facing upwards. Refer to Figure N: Roof Cover.
2. With assistance, pull the Cover over the frame. Make sure that the Roof Cover is centered on the frame. Use
a ladder if necessary. If small adjustment is needed, two people should pull together from the same end of the
Greenhouse so that the Roof Cover does not become twisted.
Fabric Tube
Black
Straps
15
Fabric
Tube
Figure N: Roof Cover
3.
Remove the M6 Nuts (12), M6 x 40 Bolts (13), M6 Washers (14), and 3‑Way Bottom Rail Clamps (10) to detach
one Bottom Rail assemby (4, 5). Insert the Bottom Rail assembly into the fabric tube on one side of the
Roof Cover (15), as shown below. Reattach the Bottom Rail to the Corner Legs (6) using the just-removed
hardware. Only finger tighten the Nuts at this point.
4. Repeat step #3 above for the other side of the Roof Cover.
5. Make sure the Bottom Rails are level, horizontal, and of the same
height from the ground, then tighten all Nuts (12).
Fabric
Tube
Bottom
Rail
15
Figure O: Insert Bottom Rails
6. Secure the four corners to the Corner Legs (6) using Ratchet Tie-Downs (11).
Refer to Securing Ratchet Tie-Downs on page 12.
Note:
The bottom edges of the Roof Cover below the Bottom Rails may be rolled
up and secured with the Ball Tie-Downs (22) for ventilation if required.
SAFETY
ASSEMBL
Y
MAINTENANCE
