Page 10
For technical questions, please call 1-888-866-5797.
Item 63781
Door and Back Cover Installation
1. Position the Door Cover (17) near where you want the front of the Greenhouse, and turn it so that the zipper
faces the outside of the Greenhouse, and the warning tag faces inside.
2. Locate the webbed strap that runs through the hem on the Cover flaps and around
the perimeter of the Cover. Thread each end of the strap at the bottom of the Cover
through the spindle of a Clasp (21) to keep the strap in place during assembly.
3. From the inside, place the gap at the top center of the Door Cover around the
3-Way Ridge Connector (7) and wrap the Cover flaps around the Rafters (1), as
shown below. Unlock the strap buckle, slip the strap around the 3-Way Ridge
Connector and relock the buckle.
Note that the Door Cover’s flaps wrap around the Rafters, and the strap is positioned inside the frame.
DO NOT ATTEMPT TO INSERT ANY FRAMEWORK TUBING INTO THE HEM ON THE COVER FLAPS.
Zipper
17
7
8
9
7
1
Hem on
Cover flap.
Strap Buckle
Figure L: Door Cover Installation
4. Repeat step #3 for the 3-Way Side Connectors A/B (8, 9) so that the
Door Cover (17) looks as shown in the illustrations above.
5. Use the previously attached Clasps (21) to attach the Cover to the
Corner Legs (6). Insert the S-Hooks on the Clasps into the inside holes on the
Corner Legs. Pull strap to tighten. Refer to Figure M: Securing Door Cover.
NOTICE: Excessive tightening will damage straps, Covers, and Corner Legs.
6. Repeat steps #1 – 5 above to install the Back Cover (16)
to the other end of the Greenhouse.
Clasp
21
6
Figure M: Securing
Door Cover
SAFETY
ASSEMBL
Y
MAINTENANCE
