Setting Command
Section 5-6
5-37
5-6-2 Reader/Writer AFI Read (AF): ISO Mode Only
In ISO mode, you must set and read AFI of the Reader/Writer. When you set AFI enable, only Tags,
which has the same AFI, can be communicated. When the setting is “00”, the communications are
enabled.
<Command Format>
STX
Node No..
Command code
“AF”
AFI
ETX
BCC
1
2 2 2
1
1
AFI
Specifies AFI in hexadecimal.
Specification range:00h to FFh (factory setting “00”)
For “*”, the Reader/Writer reads and writes current setting of AFI.
<Response Format>
STX Node
No..
Retry
flag
Command code
“AF”
Response
code
“00”
AFI
ETX
BCC
1 2 1 2
2
2 1
1
Response code
00: normal completion
For other response codes, refer to 5-2-4 Response code List.
AFI
Specifies AFI in hexadecimal.
Note
•
A setting becomes valid after executing Reset Command. To keep the
setting valid next startup, you need to save with Setting Write Command
(refer to 5-6-14 EW Command).
•
This command is for ISO Mode Only. The command is not available in
I.CODE1 mode.
