Setting Command
Section 5-6
5-47
5-6-12 Offline Mode Setting (FL)
This command selects whether the Reader/Writer will start in offline mode or offline mode.
When offline mode is selected, the Reader/Writer will perform EAS check independent of the host,
and output a signal from the output port (OUT1) if the result exceeds the specified criterion.
<Command Format>
STX Node
No. Command
code
"FL"
On/OFF
mode
Time Threshold
ETX
BCC
1 2
2 1 2 2
1 1
Specify the number corresponding to the mode in which the Reader/Writer
will start.
Specification range: 0, 1, *
When * is specified, the Reader/Writer reads the current setting.
Specification
number
0 1 *
On/OFF mode
On/OFF mode
Online mode
Offline mode
-
Time (*100ms)
Specify the length of time in HEX for which the signal will be output to
OUT1 in offline mode.
Specification range: 01 to FFh (100ms to 22.5s)
When * is specified, the Reader/Writer reads the current setting.
Threshold (%)
Specify the threshold in HEX to be output to OUT1 in offline mode.
Specification range: 00h to 64h (%)
(Refer to EAS Check Command.)
When * is specified, the Reader/Writer reads the current setting.
<Response Format>
STX Node
No. Retry
flag
Command
code
"FL"
Response
code:
"00"
On/OFF
mode
Time Threshold
ETX
BCC
1 2 1 2
2 1
2 2
1
1
Response code:
00: Normal completion
For other response codes, refer to 5-10 Response Code List.
On/OFF mode
Indicates the number corresponding to the specified On/Off mode.
Time
Indicates the time corresponding to the specified On/Off mode.
Threshold
Indicates the criterion corresponding to the specified On/Off mode.
Note
•
The default value for the threshold is 19 h (25%) and that for the output
time is 500 ms.
•
The setting becomes effective after resetting using the Reset Command.
•
In order to make your setting survive system shutdown, you need to save
the Setting Write Command (refer to EW Command in 10, 5-2-4) in the
EEPROM.
•
The command related to this is the EAS Setting (refer to EA Command in
6, 5-2-2) and EAS Check (refer to EA Command in 7, 5-2-2).