Wiring Method
Section 4-4
4-15
5) Soldering
Soldering iron to use
Conductor cross-sectional area
(mm
2
)
30W
0.5
6) Reassemble the connector as follows.
Screw the barrel into the end bell and secure it with Set Screw A.
Push the cable packing and washer into the end bell, secure the end bell,
and screw the clamp nut in.
After swinging the cable in various directions to settle the parts on the
cable (Fig. 1), re-tighten them to the specified torques and secure them
with Set Screw B.
(Fig. 1)
•
Tightening torque for screws
Unit:N
•
m
End bell
0.010 - 0.015
Clamp nut
0.015 - 0.020
Set Screws A and B
0.002 - 0.003
Caution
Model name of connector plug for host communications:
NJW-165-PM7
from Nanaboshi Electric Mfg. Co., Ltd.
Model name of I/O connector plug: NJW-2010-PM10 from Nanaboshi
Electric Mfg. Co., Ltd.
Waterproofing effects vary depending on the finish of the cable envelopes
and the condition of the materials inside the cable. Before use, be sure to
check for the proper torques and the waterproof effects of the cable of your
choice. OMRON does not offer any guarantee for customer-made cables.
Please inquire to the manufacturer for details of these connectors.
(1) Insert the pre-soldered wire into the solder
pot of the contact.
(2) Heat the contact and the conductors with a
soldering iron.
(3) Pour solder to fill the opening between the
contact and the conductors.
Iron tip
Solder
Wire
Contact
Clamp nut
Cable packing
End bell
Coupling nut
Barrel
Set screw B
Washer
Set screw A
Cable
!
Fig.1
