Setting Command
Section 5-6
5-36
5-6 Setting
Command
5-6-1 Reader/Writer AFI Enable/Disable Changeover (AE): ISO Mode
Only
In ISO mode, you must set AFI of the Reader/Writer either enable or disable when communicating
with a Tag. If you set AFI enable, only Tags, which has the same AFI, can be communicated. When
you set AFI disable, the communications are enabled no matter AFI in Reader/Writer is set or not.
<Command Format>
STX
Node No..
Command code
“AE”
AFI
Set-
ting
ETX BCC
1 2
2 1
1
1
AFI enable/disable Specifies either valid or invalid of AFI setting in Reader/Writer.
0: invalid (factory setting)
1: valid
For “*”, the Reader/Writer reads and writes current settings.
<Response Format>
STX Node
No..
Retry
flag
Command code
“AE”
Response
code
“00”
AFI
Set-
ting
ETX BCC
1 2 1 2
2 1
1
1
Response code
00:normal completion
For other response codes, refer to 5-2-4 Response code List.
AFI valid/invalid
Indicates valid/invalid of AFI in hexadecimal.
Note
•
A setting becomes valid after executing Reset Command. To keep the
setting valid next startup, you need to save with Setting Write Command
(refer to 5-6-14 EW Command).
•
This command is for ISO Mode Only. The command is not available in
I.CODE1 mode.