Omron TJ1-MC04, Programming Manual

Page: 165 / 312

Communication protocols
PROGRAMMING MANUAL 165
Revi
si
on 3.0
Set up
You need the SETCOM command to set up the serial port of the TJ1-MC__
for the Host Link Slave protocol. Set the command as follows:
SETCOM(baudrate, data_bits, stop_bits, parity, port, 5)
After you have set this command, the TJ1-MC__ responds to Host Link
commands from the master with the specified node number. You can set this
node number with the
HLS_NODE parameter.
Example
In this example we assume this set-up:
•
A Trajexia system with a TJ1-MC__.
• An NS8 programmable terminal.
• A connection from the serial port of the TJ1-MC__ to the programmable
terminal. The serial port uses RS232C communication.
/i
4.3.3 User-defined protocol
You can implement a user-defined communication protocol with these
commands:
/i
Example
Assume a set-up with:
•
A Trajexia system with a TJ1-MC__.
• An OMRON Vision system F500.
• A connection from the serial port of the TJ1-MC__ to the F500. The
serial port uses RS232 (port 1) communication.
This program sends a Vision command through the serial port, reads the
response from the Vision system, writes it to VR variables and prints the
results in the Terminal window of Trajexia Tools.
A4 Aborted due to
format error in
transmission
data The command format did not
match the number of bytes in the
second or later frame. Correct the command
data and transfer the
command again.
A5 Aborted due to
entry number
data error in
transmission
data There was an entry number data
error in the second or later frame
or a data length error. Correct the command
data and transfer the
command again.
A8 Aborted due to
frame length
error in trans-
mission data The length of the second or later
frames exceeded the maximum
of 128 bytes. Correct the command
data and transfer the
command again.
Example Configuration of the Host Link slave.
End code Description Probable cause Solution BASIC code ' Define Host Link slave node
HLS_NODE = 15
' Define Host Link slave model code
HLS_MODEL = $FA
' Set up Host Link slave for port 1
SETCOM(9600,7,2,2,1,5)
Result The TJ1-MC__ can communicate with the programmable terminal.
BASIC command Description
SETCOM SETCOM configures the serial communication port, and it enables
the Host Link protocols.
GET GET assigns the ASCII code of a received character to a variable.
INPUT INPUT assigns numerical input string values to the specified varia-
bles.
KEY KEY returns TRUE or FALSE , when a character has been received
or has not been received.
LINPUT LINPUT assigns the ASCII code of received characters to an array
of variables.
PRINT PRINT outputs a series of characters to a serial output device.
I52E-EN-03.book Seite 165 Freitag, 29. Juni 2007 11:55 11