5. Applicable Devices and Support Software
5.2.
Device Configuration
The hardware components to reproduce the connection procedure of this document are as
follows.
E3X-ECT
Personal computer
(Sysmac Studio installed,
OS:Windows7)
6
Manufacturer
Name
Model
Version
OMRON CPU
Unit
(Built-in EtherCAT port)
NJ501-1500
OMRON
Power Supply Unit
NJ1W-PA3001
OMRON Sysmac
Studio
SYSMAC-SE2[][][] Ver.1.01
- Personal
computer
(OS:Windows7)
- USB
cable
(USB 2.0 type B connector)
OMRON
Ethernet cable (with industrial
Ethernet connector)
XS5W-T421-[]M[]-K
OMRON Sensor
Communications
Unit
(EtherCAT slave)
E3X-ECT
OMRON Fiber
Sensor
E3X
-
HD0
Precautions for Correct Use
The connection line of EtherCAT communication cannot be shared with other networks, such
as Ethernet or EtherNet/IP.
The switching hub for Ethernet cannot be used for EtherCAT.
Please use the cable of Category 5 or higher, double-shielded with aluminum tape and
braided shielding and the shielded connector of Category 5 or higher.
Connect the cable shield to the connector hood at both ends of the cable.
Additional Information
For information on the specifications of the Ethernet cable and network wring, refer to
Section
4 EtherCAT Network Wiring
in the
NJ-series CPU Unit Built-in EtherCAT Port User's Manual
(Cat. No. W505).
Additional Information
The system configuration in this document uses USB for the connection between the
personal computer and the NJ-series CPU Unit. For information on how to install a USB
driver, refer to
A-1 Driver Installation for Direct USB Cable Connection
of the
Sysmac Studio
Operation Manual
(Cat.No. W504).
USB cable
NJ501-1500
(Built-in EtherCAT port)
E3X-HD0 (3 units)
Ethernet cable
Summary of Contents for Sysmac NJ-series
Page 32: ...2013 0911 P529 E1 01...