16
Starting the SensorSupportSoftware
Section 5-1
5-1
Starting the SensorSupportSoftware
•
Start the program by double-clicking the
SensorSupportSoftware
pro-
gram icon in the
OMRON\SensorSupportSoftware
program group
.
After the program has started, the
SensorSupportSoftware
runs an auto-
matic interface check, including sensor selection and detection.
In this example, a sensor has been found at the serial COM1 interface. This
sensor's setting is read and the
Sensor selection
window is closed.
The
Sensor selection
window stays open if several sensors are
detected. In this window, the sensors found can be selected for setting
by clicking the relevant
Sensor Selection
button.
Sensor Selection
The sensors found are selected for setting by clicking the Sensor
Selection button.
Repeat
Sensor detection can be repeated by clicking the Repeat button.
No sensor detected
Indicates that no sensor is connected to the relevant interface.
Not available
Indicates that the relevant interface is not installed or is already
occupied.
Summary of Contents for SENSOR SUPPORT SOFTWARE S3
