Omron NYP - 1 Series, Hardware User Manual

Page: 216 / 266

Item Default / Remark
CPU CPU Information Display of CPU parame-
ters
Set Boot Freq Ratio 255
Hyper-Threading
*2 *1
Enabled
Active Processor Cores All
Limit CPUID Maximum Disabled
Execute Disable Bit Enabled
Intel Vitalization Technology Enabled
Hardware Prefetcher Enabled
Adjacent Cache Line Prefetch Enabled
CPU AES
*2 *1
Enabled
EIST Enabled
- Turbo Mode
*2 *1
Enabled
- Energy Performance
*2 *1
Performance
P-State Reduction
*3
Disabled
CPU C States Disabled
TCC Activation Offset 0
Intel TXT(LT) Support
*2 *1
Disabled
SATA SATA Controller(s) Enabled
SATA Mode Selection AHCI
SATA Test Mode Disabled
Aggressive LPM Support Disabled
SATA Controller Speed Default
Serial ATA Port 0, 1, 2, 3
*5
SATA Port
Enabled
*5
Hot Plug Disabled
External SATA Disabled
SATA Device Type Hard Disk Drive
Spin Up Device Disabled
Memory Configuration Display of memory pa-
rameters
Intel (R) Rapid Start Technology Disabled
USB XHCI Mode Enabled
Overcurrent Protection Disabled
USB Ports Per-Port Disa-
ble Control USB Ports Per-Port Disa-
ble Control Enabled
- USB Port 0...6 Enabled
- USB 3.0 Port 0...1 Enabled
Legacy USB Support Enabled
External USB Controllers Support Enabled
XHCI Hand-off Enabled
EHCI Hand-off Disabled
USB Mass Storage Driver Support Enabled
USB Transfer Timeout 20 sec
Device Reset Timeout 20 sec
Device Power-up Delay Selection Auto
Generic Ultra HS-COMBO Auto
Appendices
A-8
NY-series Industrial Panel PC Hardware User's Manual (W555)