8
Fiber Laser Marker MX-Z2000H-V1 series User’s Manual (Z416)
• If you feel a sense of error, immediately stop using the product and turn off the power supply, and contact your OMRON
representative.
• Do not move the product with the cable still attached.
• Do not cut the fiber cable. If the fiber cable is cut accidentally, please stop using the product and consult your OMRON
representative.
Observe the following points to prevent the product from becoming inoperative or malfunctioning, or to avoid adverse effects on its
performance or device.
1. Power Supply, Connection and Wiring
• Never bundle the marker head control cable and the marker head power supply cable together with 200/100 [VAC] power wires or
the power wire or control wire of the AC motor, AC servo motor, or electromagnetic valve, etc. that is being used on your
system.Bundling them together will cause noise to enter the galvanometer control cable and the I/O cable for the external control
device, which may result in a laser marker malfunction.
• If there is a surge in the power supply line, connect a surge absorber depending on the operating environment.
• Do not step on the cables.
2. Operating Environment
• To prevent power supply noise or radiant noise from occurring, be sure to implement measures against noise, such as a spark
killer, at the locations where a surge can occur, such as the point of contact with the motor used for surrounding devices.
• Refrain from using a cellular phone as it may cause the laser marker to malfunction.
3. Work materials
Follow the instructions below when using this product with gold, silver, copper, or other highly reflective materials. Reflected beams
may damage the marker head.
(1) For a work positioned horizontally to the marker, do not mark within 6 mm of the center of the marking area.
(2) If the marking surface of the work is slanted or curved, ensure that the specular reflection beam is not reflected back into the
marker head.
Please consult with our sales center when using this product within these conditions.
4. Maintenance Inspection
• If the cover glass of the marker head laser irradiation port gets dirty, the laser output may drop or a failure may occur. Do not use
this product while the cover glass is dirty.
• Do not use thinner, benzene, acetone or kerosene items to clean the marker head or the controller. Carefully remove dirt or dust
on the cover glass without scratching it by moistening with cleaning agent a piece of cleaning paper specifically for use on an
optical device.
5. Storage
Do not store the product in an environment described below.
• Storage temperature: -10 to 60
°
C (Non condensation or freezing)
• Storage humidity: 35 to 85% RH (No condensation)
• Outdoor or area subject to direct sunlight
• Area where corrosive gas, flammable gas, oil or mist may be present
• Area that is constantly vibrating or subject to startling vibration
• Very dusty area
The aforementioned points do not guarantee any unforeseen situations that may arise from storing of the product.
Notes on Operation
㽢
(1)
φ6
×
(2)