7
Fiber Laser Marker MX-Z2000H-V1 series User’s Manual (Z416)
Be sure to observe the following points that are necessary to ensure safety.
1. Usage
This product was developed and manufactured to be integrated with systems, machines, equipment and so on in an industrial
environment. When using this product, follow all applicable standards, laws and regulations. Also, the customer is responsible for
confirming the compatibility of the product.
2. Installation Location
Do not install the product in any of the following environments.
• Area with an ambient temperature that exceeds the rated range
• Area with sudden temperature shift (area where condensation can occur)
• Area with a humidity level that exceeds the 35 to 85% RH range
• Area subject to direct sunlight or near a heating appliance
• Area where a ferromagnetic field or an intense electric field is present
• Area where a carrier machine, etc. moves
• Area where corrosive gas or flammable gas is present
• Area where dust, salt, or iron powder is present
• Area where water, oil or chemical splashes or mist may be present
3. Power Supply, Connection and Wiring
• Do not use a voltage that exceeds the rated voltage or AC power source.
• Make the separate wiring for high-voltage line, power wire and power to the product. Using the same wire or duct will result in
induction, which then may cause malfunction or damage.
• Use the dedicated cables that are specified in this document.
• Connect the controller power supply cable to a 3P outlet with grounding (D-class grounding). If a D-class grounding is not used,
there is a risk of electric shock.
• Use SELV (Safety Extra Low Voltage) circuit for all external circuits connected to this product. SELV is an ungrounded circuit
separated from dangerous voltage by double insulation or higher insulation, and it does not exceeds safe voltage (peak 42.4 V or
60 V (DC)) even in single failure condition.
"Fiber Laser Marker MX-Z2000H-V1 series Setup Manual" (Z415)
4. Interlock
The product is equipped with the shutter interlock function. Use it for remote interlocks, etc.
Set the terminal of the input terminal block [EMERGENCY A] (emergency stop input A) or [EMERGENCY B] (emergency stop input
B) to open (OPEN) to forcibly close the shutter inside the marker head and stop the laser emission.
When constructing an interlock system according to Category 3 indicated in International Standards ISO13849-1 (JIS B 9705-1)
(classification of the safety-related parts of a control system in respect to their resistance to faults and their subsequent behavior
under the fault condition), use the interlock terminal.
"Fiber Laser Marker MX-Z2000H-V1 series Setup Manual" (Z415)
5. Emission Direction
The product assumes laser emission in the downward direction. When setting the emission direction to a direction other than
downward, at your own risk, please thoroughly implement safety measures, as well as protective measures to prevent dust from
sticking to the cover glass.
6. Dust and Gas Generated during Marking
Dust or gas generated during marking can cause damage to the laser oscillator or the optical system. Be sure to protect the laser
marker by collecting the dust or gas generated during marking.
When using a suction duct to suck in fine particles, such as metal, oxidized and carbide material, generated during marking, welding,
cutting or other processes, use a duct with straight interior walls with which fine particles are hard to accumulate, and install the duct
so that fine particles do not accumulate. Furthermore, periodically clean the inside of the duct to prevent fine particles from
accumulating and to prevent a dust explosion.
7. Other
• Do not disassemble, repair, modify, change the shape by pressure, or incinerate this product.
• When disposing of the product, follow the instructions of the local government and other authorities and dispose of it as industrial
waste.
• Connect the dedicated products (marker head, controller and cable). Use of non-dedicated products may lead to malfunction or
failure.
Safety Points
