6
Fiber Laser Marker MX-Z2000H-V1 series User’s Manual (Z416)
In rare cases, property damage may result.
When using the product, be sure to observe the installation conditions and provide necessary space for it.
Do not use the product in any of the following environments as the product may, in rare cases, be damaged.
(a) Dusty area
(b) Area with oil mist floating in the air
(c) Area subject to impact or vibration
(d) Area with high humidity (of 85% RH or higher)
(e) Wet floor surface
(f) Installation on a table other than an affixed frame (movable part)
Securely tighten the marker head with screws and provide appropriate amount of space.
In rare cases, the product may be damaged.
Be sure to conduct periodic inspections to maintain the level of product performance and to ensure safety.
In rare cases, property damage may result.
Do not bend the optical fiber cable to a radius of 100 mm or less, or apply excessive load or impact to it.
Do not move the marker head by holding or pulling the fiber cable.
Touching it may, in rare cases, cause a burn due to high heat.
Do not touch while the power is being supplied or immediately after the power is turned off.
In rare cases, the product may be damaged.
Do not touch the cover glass with bare hands.
Conducting maintenance in an unnatural posture may, in rare cases, result in an injury or other personal injury.
Provide a space for maintenance when installing the product.
A serious personal injury may result.
Be sure that excessive force is not placed on the area above the caution label for falling on the side of the controller.
When transporting the marker head, be sure to hold the concaved section in front and handle at the back with both
hands.
If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment
may be impaired.
Caution
