13/07/2016 14:23
Blood pressure measurement module M3500
Page 7 of 8
https://translate.googleusercontent.com/translate_c?depth=1&hl=…03%3Fview%3Dbody&usg=ALkJrhhqzooj9yOkvRDfve8nZaQansOoVg#WARNING
1.
2.
3.
1.
2.
3.
However, this is a case that has been used in the recommended environment, such as regular
maintenance and inspection, there may be a difference through the use situation arises.
Matters relating to the maintenance and inspection
[User, and skilled in the art by the maintenance and inspection matters]
Notes
- For a while when you re-use the equipment that was not used, make sure that you always the
equipment before use to operate successfully and safely.
- Body, accessories, connector, in the opening portion of the housing, with blowing liquid Ketari,
pouring, please do not spill. Otherwise, you may get an electric shock.
- Disposable products in order to prevent infection, do not re-use. (There is also a thing that can
be re-used only the same person to be measured.)
- Do not use paint thinner, solvents such as benzene to clean. These solvents will damage the
surface of the plastic.
Inspection before use
- In appearance, there is no deformation such as by dropping, Ri was dirty, Please check not wet.
Cuff, please make sure that you are using the specified ones.
Inspection after the power is turned on
- Smoke or out, or there is no strange smell, please check whether the abnormal noise is not
heard.
[Maintenance and inspection matters by the trader]
Notes
- Clean, because there is a risk of electric shock, please be performed by far the communication
connector.
* Please insert the communication connector After cleaning from the well dried.
• The unit, autoclave, can not be used gas sterilization (formaldehyde gas, EOG, high
concentration ozone, etc.). The equipment will cause a deterioration.
Inspection before use
· That the cords are not damaged (exposure of the core, disconnection, etc.),
Please make sure that there is no slack in the cords of connection.
- Please check do not place heavy objects on top of the code.
Inspection after the power is turned on
• Press the each switch, make sure that the function is activated.
• Each measurement is performed normally, please make sure the measurement error is within
the reference value.
