35
2.
Installation and wiring
2.5 Pulse output wiring (continued)
• Checking Connections
• After the insertion, pull gently on the wire to make
sure that it will not come off and the wire is securely
fastened to the terminal block.
• To prevent short circuits, insert the stripped part of a
stranded or solid wire or the conductive part of a
ferrule until it is hidden inside the terminal insertion
hole. (See right diagram.)
2 Removing Wires from Push-In Plus
Terminal Block
Use the following procedure to remove wires from the
terminal block. The same method is used to remove
stranded wires, solid wires, and ferrules.
1 Hold a flat-blade screwdriver at an angle and
insert it into the release hole.
2 With the screwdriver still inserted into the release
hole, remove the wire from the terminal insertion
hole.
3 Remove the flat-blade screwdriver from the
release hole.
2 Removing Wires from Push-In Plus Terminal Block
• ecommended Flat-blade Screwdriver
Use a flat-blade screwdriver to connect and remove wires.
Use the following flat-blade screwdriver.
10〜12°
Flat-blade screwdriver
1
3
2
Model
Manufacturer
XW4Z-00B
Omron
Side
Front
2.5 dia.
2.5 mm
0.4 mm