34
2.
Installation and wiring
2.5 Pulse output wiring (continued)
Cautions when connecting the Push-In Plus terminal (RS-485 communication
terminal and pulse output terminal)
Follow the below steps when connecting the Push-In Plus terminal
1 Connecting Wires to Push-In Plus Terminal Block
• Part Names of the Terminal Block
• Connecting Wires with Ferrules and Solid Wires
Insert the solid wire or ferrule straight into the terminal
block until the end strikes the terminal block.
If a wire is difficult to connect because it is too thin,
use a flat-blade screwdriver in the same way as when
connecting stranded wire.
• Connecting Stranded Wires
Use the following procedure to connect the wires to
the terminal block.
1 Hold a flat-blade screwdriver at an angle and
insert it into the release hole. The angle should be
between 10
e
and 12
e
. If the flat-blade screwdriver
is inserted correctly, you will feel the spring in the
release hole.
2 With the screwdriver still inserted into the release
hole, insert the wire into the terminal hole until it
strikes the terminal block.
3 Remove the flat-blade screwdriver from the
release hole.
Terminal
(Insertion) hole
Release hole
Release hole
Terminal (Insertion) hole
Ferrules and Solid Wires
10〜12°
Flat-blade screwdriver
3
2
1