26
2.
Installation and wiring
2.1 Attaching the body of the unit (continued)
4
Raise the DIN hook and fix the body to the DIN rail
Detaching the body of the unit
When removing the body from the DIN rail, use a flathead screwdriver to flick open the DIN hook and open
downwards.
Information
• You can attach multiple model KM-N2 to the DIN rail and fit the bodies next to each other.
Important
• Ensure that the DIN rails and the body are attached properly. Looseness may cause the DIN rails, body,
and wires to separate if vibrations or impacts occur.
• Fix end plates to the body units at each end of the DIN rail.
These stop the units from jumping off the DIN rail due to vibration or impacts.
– End plate (recommended part): model PFP-M (from Omron)
• Make sure you install so there is space for wiring above and below the body of the unit.
(about 50mm above the unit and 30mm below the unit)
Raise
