![background image](http://html1.mh-extra.com/html/omron/fz-series/fz-series_instruction-manual_1633219008.webp)
7
Lit while power is ON.
Lit while the controller is in Run Mode.
Lit when an error has occurred.
Connect the controller to external devices such as a sync sensor and PLC.
Connect cameras.
Connect a DC power supply. Wire the power supply unit independently
of other devices. After wiring, replace the terminal cover.
Connect the ground wire. Make sure that the controller is grounded with a
separate ground wire.
Connect a monitor.
Connect an external device such as a personal computer or PLC.
Connect a track ball, mouse and USB memory. A total of four USB ports are provided and any of them can be
used. However, when connecting two or more USB memories, do not connect them to adjacent ports. Doing so
may cause the USB memories to come into contact, resulting in malfunction or damage.
Connect the controller to a personal computer.
A touch pen is stored. (Provided with the LCD integrated type only)
Camera connector
Camera connector
Ethernet connector
Ethernet connector
Monitor connector (analog RGB)
Monitor connector
(analog RGB)
Power/ground terminal
POWER LED
USB connector
USB connector
RS-232C/RS-422 connector
RS-232C/RS-422
connector
I/O connector (control lines, data lines)
I/O connector
(control lines, data lines)
• The following items can be connected to USB ports. • Commercially available track ball and mouse • USB memory
• Never insert/remove USB devices during measurement. Doing so may affect measurement time.
Power Supply and Wiring p.3
Front view
Left-side view
Right-side view
Power/
ground
terminal
RUN LED
ERROR LED
POWER LED
RUN LED
ERROR LED
USB connector
•
Box type FZ3-350-10/FZ3-355-10/FZ3-H350-10/FZ3-H355-10/FZ3-750-10/FZ3-755-10
FZ3-H750-10/FZ3-H755-10/FZ3-950-10/FZ3-955-10/FZ3-H950-10
FZ3-H955-10/FZD-550-10/FZD-555-10
•
LCD integrated type FZ3-300-10/FZ3-305-10/FZ3-H300-10/FZ3-H305-10/FZ3-700-10/FZ3-705-10
FZ3-H700-10/FZ3-H705-10/FZ3-900-10/FZ3-905-10/FZ3-H900-10
FZ3-H905-10/FZD-500-10/FZD-505-10
Power Supply Wiring
Touch pen (holder)
24VDC
+
–
Component Names and Functions
6 7
1
2
3
1
2
3
10
4
4
5
5
6 7
8
8
9
9
10
10
11
11
1
2
3
4
5
6
7
8
9
10
11
12
12
• The touch pen must be stored so that the pen tip faces to the right when viewed toward the controller.
• To remove the touch pen, push the left side (handle) of the pen to the rear. The pen
’
s right side (pen tip) will pop out, so
hold and remove the pen.
fz3_4ch_setup_E.book Page 7 Friday, August 7, 2009 5:45 PM