4
•
Noise Resistance
• Do not install the product in a cabinet containing
high-voltage equipment.
• Do not install the product within 200 mm of power cables.
•
Component Installation and Handling
• OMRON Components
Use only the camera and cables designed specifically for the product.
Failure to observe this may result in malfunction or damage of the product.
• Connecting/Disconnecting Camera and Cables
Always turn OFF the Controller’s power before connecting or disconnecting a camera or cable.
• Touching Signal Lines
To prevent damage from static electricity, use a wrist strap or another device for preventing electrostatic discharges when touching
terminals or signal lines in connectors.
• Handling a USB Memory
To remove a USB memory, make sure that data is not being read or written to it.
The LED on the USB memory flashes while data is being read or written, so make sure that it is lit steadily before removing the
memory.
• Turning OFF the Power
Do not turn OFF the power while a message is being displayed indicating that processing is being performed. Data in memory will
be corrupted, and the product may not operate correctly the next time it is started.
• Using the RESET Signal
Do not use the RESET input immediately after power is turned ON. When using the RESET input to synchronize startup timing,
wait at least 15 second after the Controller’s power supply is turned ON before turning ON the RESET signal.
•
Maintenance
Turn OFF the power and take safety precautions before conducting inspections. Electrical shock can result from attempting safety
inspections with the power turned ON.
• Clean the lens with a lens-cleaning cloth or air brush.
• Lightly wipe off dirt with a soft cloth.
• Dirt on the CCD must be removed using an air brush.
• Do not use thinners or benzene.
Confirming Package Contents
• Controller
• Instruction Manual (this manual)
• Booklet (“Please Read First”)
• Mounting bracket (for panel)
• Touch pen
Qty.: 1
Qty.: 1
Qty.: 1
Qty.: 6
* Supplied with the LCD integrated type only.
Qty.: 1
* Supplied with the LCD integrated type only
(provided inside the controller).
•
Communication with High-order Device
After confirming that this product is started up, communicate with the high-order device.
When this product has started up, an indefinite signal may be output from the high-order interface.
To avoid this problem, clear the receiving buffer of your device at initial operations.
U.S. California Notice:
This product contains a lithium battery for which the following notice applies :Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
fz3_4ch_setup_E.book Page 4 Friday, August 7, 2009 5:45 PM
