Omron F3SJ-B0185P25, User Manual

Page: 127 / 149

111
F3SJ-E/B
User’s Manual
Ch
apt
e
r
5
Pre-
Op
erat
ion Chec
klis
ts
Checklists
E
 Power supply's 0 V must be grounded.
 Wiring must not be bent, cracked, nor damaged.
 Operation check while the machine is stopped
 The test rod is not deformed.
Use a test rod with an appropriate diameter for inspection.
 The sensor can detect a test rod wherever it is in the detection zone. In other words, when a test rod
is inserted into the detection zone, the stable-state indicators (STB) turn off and the ON/OFF output-
state indicators turn red.
 When the external test function is used:
ON/OFF-state indicators turn red when the test input line is short-circuited to Vs-3V to Vs.
 When the external device monitoring function is used:
When the F3SJ-B is blocked and the external device monitoring input terminal is open, it enters a
lockout state.
 When the manual reset function is used:
After the F3SJ-B is turned ON, the ON/OFF-state indicators must remain red, even if the F3SJ-B is
not blocked. The reset input must turn the ON/OFF-state indicators to green.
After that, when the F3SJ-B is blocked and returned to unblocked state when the ON/OFF-state
indicators are green, the ON/OFF-state indicators remain red. The reset input must turn the ON/OFF-
state indicators to green.
 When using muting lamp:
Under muting state, a signal that indicates muting state is output to the auxiliary output.
Under override state, a signal that indicates override state is output to the auxiliary output.
 Checking that hazardous parts stop while the machine operates

The hazardous parts stop immediately when a test rod is inserted into the detection zone at three
positions: "directly in front of the emitter", "directly in front of the receiver", and "between the emitter
and receiver". (Use the appropriate test rod.)

The hazardous parts remain stopped as long as the test rod is in the detection zone.

The hazardous parts stop when the power of the F3SJ-E/B is turned OFF.

The actual response time of the whole machine is equal to or less than the calculated value.
Start
Stop