Omron E2 ELITE HV-F127-E, Instruction Manual

Page: 15 / 146

15
EN
3.Maintenance
3.3 Troubleshooting
* If the unit does not operate after taking the above-mentioned measures, contact the nearest OMRON dealer.
Problem Cause Remedial Action
 The power cannot
be switched on.  The batteries are wrongly inserted. ⇒ Insert the batteries according given directions.
 The power switches
off to soon.
 The power switches
off while the unit is
in use.
 The pads are not properly attached to the
skin.
 The pads are removed from the skin·
 The batteries are worn out or empty.
 The power turns automatically off after
15 minutes.
 The electrode cord is broken.
⇒ Reattach the pads securely to the skin. (Otherwise
power will switch off automatically).
⇒
Switch off the unit before removing the pads from the
skin.
⇒
Replace with new batteries, following given
directions.
⇒ Replace the electrode cord with a new one.
 The pads do not
attach to the skin.
 The clear film on the adhesive surface of
the pad has not been removed.
 The adhesive surface of the pad is dirty.
 The pads are used directly after washing
them.
 The adhesive surface of the pads is
damaged.
⇒
Remove the film.
⇒
Clean the pads, following given directions.
⇒
After washing, allow the pads sufficient time for
drying.
⇒
Replace the pads with new ones.
 The stimulating
effect cannot be felt.

The pads may have been used while
perspiring.
 The pads may have been washed too long
and too frequently.
 The pads may have been stored under
high humidity, high temperature or in direct
sunshine.

The pads are not in close contact with the
skin.
 The pads are attached, but overlapping
each other.
 The electrode cord is not connected
properly.
 The intensity is at a too low level.
 The batteries are worn out or empty.
 The adhesive surface of the pads is
damaged.
⇒
Leave the pads in a refrigerator overnight.
⇒
Reattach the pads to the skin properly.
⇒
Reattach the pads to the skin while assuring they do
not overlap.
⇒
Connect the electrode cord properly.
⇒
Increase the intensity.
⇒
Replace the batteries with new ones, following
direction given.
⇒
Replace the pads with new ones.
 The skin turns red.
 The skin feels
irritated.
 The treatment has continued too long.
 The pads are not in close contact with the
skin.
 The adhesive surface of the pads is dirty or
dry.

The adhesive surface of the pads is
damaged.
⇒ Limit the treatment time to the programmed
15 minutes.
⇒ Reattach the pads to skin properly.
⇒ Wash the pads, following given directions.
⇒ Replace the pads with new ones.
HV-F127 manual.book Page 15 Monday, December 29, 2014 3:34 PM