1-6
Section
Preparation for Operation
27
4. Initial Settings
•
Turn OFF the CPU Unit’s Communications Switch, if necessary.
(When this switch is OFF, communications with devices other than the
Programming Console are governed by the settings in the PC Setup.)
•
Connect the Programming Console, set the mode switch to PROGRAM
mode, and turn ON the PC.
•
Check the CPU Unit’s LED indicators and the Programming Console’s dis-
play.
•
Clear the PC’s memory. (All Clear)
•
Make PC Setup settings.
Refer to
3-3 Installing the CPM2A
for details.
5. Create Ladder Program
•
Create a ladder program to control the system.
Refer to the
Programming Manual
for details.
6. Write Ladder Program in PC
•
Write the ladder program in the PC with the Programming Console or
transfer the program to the PC from the Support Software.
Refer to
Section 4 Using Programming Devices,
to the
SYSMAC Support
Software Operation Manuals
and to the
CPT User Manual
for details.
7. Test Run
•
Check I/O wiring in PROGRAM mode.
•
Check and debug program execution in MONITOR mode.
Refer to
Section 5 Test Runs and Error Processing
for details.
