2-1 Organization of this Manual
2
2
SYSMAC CP1L Getting Started Guide
21
Designing
Systems
z
Workflow from Design to Operation
The workflow for constructing a CP1L shutter control system is shown below. For details, refer
to the respective sections of the manual.
Refer to
2-3 I/O Allocation for the Shutter Control
System
.
Refer to
3-2 Mounting onto DIN Tracks
and
3-3
Wiring Devices
.
Refer to
3-4 Power Testing CP1L
.
Refer to
4-1 Preparing for Programming
.
Refer to
4-2 Creating a Ladder Program
,
4-3 Using
CX-Programmer
,
4-5 Inputting Programs
,
4-6 Saving/
Loading Programs
, and
4-7 Editing Programs
.
Refer to
5-1 Going Online
.
Refer to
5-2 Adjusting/Debugging Online
.
Refer to
5-1 Going Online
.
Preparing the equipment
· Equipment preparation
· Wire power supply and ground
· Wire I/O devices
Supplying power to CP1L
· Test PLC operation
Preparing to write program
· Install USB driver onto computer
· Connecting CP1L to a computer
Writing programs
· Enter ladder programs
in CX-Programmer
· Compile
· Save
· Edit
Going online with CP1L
and the computer
· Set the CP1L clock
· Switch to PROGRAM mode.
· Transfer the program
Online debugging
· Monitor power
· Force-set/force-reset commands
· Online Editing
Production run
I/O allocation
· Allocate relay numbers
to sensors and switches
W07E-EN-02+CP1L+GettingStartedGuide.book Seite 21 Montag, 15. September 2008 11:15 11
