A
A-4 CP1L Programming Examples
122
SYSMAC CP1L Getting Started Guide
Ap
pend
ix
System Configuration
z
Wiring Example
On CP1L units with 14-point I/O, interrupt inputs can be allocated to contacts 0.04 to
0.07.
Input interrupt 0 will be allocated to contact 0.04. The interrupt task executed by
input interrupt 0 is task No.140.
z
PLC Setup
Set contact 0.04 to be [Interrupt].
1.
Open the PLC Settings dialog box.
2.
Click the Built-in Input tab.
3.
On the IN0 drop-down list for [Interrupt Input], select [Interrupt].
While the sensor input contact is 0.04, setup is performed for [IN0] since the
interrupt input setting is set to 0.
4.
Close the PLC Settings dialog box.
5.
To apply changes made to the PLC settings, turn the PLC power ON.
PASS output 100.00
NG output 100.01
NG output sensor input 1 100.02
NG output sensor input 2 100.03
NG output sensor input 3 100.04
Sensor input (interrupt input 0) 0.04
RESET input 0.05
CP1L
0.02
0.01
0.00
Sensor input 3
Sensor input 2
Sensor input 1
W07E-EN-02+CP1L+GettingStartedGuide.book Seite 122 Montag, 15. September 2008 11:15 11
