00061258.DOC, Version 1.0
16/16
5.3 Connection with the mains
Connect the device to the mains with the supplied power supply cable. The occupation of the connection
cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green Earth
Attention!
The earth has to be connected! If the device will be directly connected with the local power supply network, a
disconnection switch with a minimum opening of 3 mm at every pole has to be included in the permanent electrical
installation. The
device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum fault current
of 30 mA.
6. CLEANING AND MAINTENANCE
Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents! There are no serviceable parts inside the device except for the fuse. Maintenance and
service operations are only to be carried out by authorized dealers.
6.1 Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead. Procedure:
Step 1:
Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2:
Remove the old fuse from the fuse holder.
Step 3:
Install the new fuse in the fuse holder.
Step 4:
Replace the fuse holder in the housing.
Should you need any spare parts, please use genuine parts. If the power supply cable of this device
becomes damaged, it has to be replaced by a special power supply cable available at your dealer. Should
you have further questions, please contact your dealer.
7. TECHNICAL SPECIFICATIONS
ISO-23
ISO-23D
ISO-23F
Power supply:
230 V AC, 50 Hz ~
Power consumption:
10 W
Connectors:
1 x stereo RCA
2 x stereo RCA
1 x stereo RCA
Maximum input level:
+22 dBu
Ouputs:
1 x stereo RCA
2 x stereo RCA
1 x stereo RCA
Maximum ouput level:
+22 dBu
Control range:
-~ to +6 dB
Lows:
20 Hz - 300 Hz
Mids:
300 Hz - 4 kHz
Highs:
4 kHz - 20 kHz
Frequency range:
20-20000 Hz
Dimensions (WxDxH):
483 x 200 x 47 mm
Weight:
2.6 kg
Please note: Every information is subject to change without prior notice. 14.06.2011 ©
