16
CHAPTER IV. SETTING UP THE FREEJET 320TX
OVERVIEW:
The FreeJet320TX Textile Printer should be set-up BEFORE connecting it to the
computer and BEFORE turning on the Main Power Switch. The Computer Software
set-up will be done BEFORE connecting the computer to the printer. (See the
“Setting Up the Computer” section of this manual.) You will need both Filtered
Power and the software configured Computer to complete the FreeJet320TX
installation and perform a Nozzle Check (after charging the ink system). A “UPS”
(Un-interruptible Power Supply/Battery Backup) or a Surge Protector is
MANDATORY FOR THE WARRANTY. The Computer (Windows XP or VISTA
Operating System) must have the Epson Stylus Photo R2880 Driver, the Epson USB
(if necessary, may not be needed for visa installations) Driver and the OmniPrint
DirectRip software and HASP USB dongle (needed to open and operate the
DirectRip).
Note: Make a backup copy of all your software installation discs as well as the
serial number of your software and the serial number of your machine. Lost
software and dongles cannot be duplicated and if lost a new one will need to
be purchased.
A. Remove the yellow shipping brackets holding the print engine in place.
B. Plug the FreeJet into a UPS power source that is plugged into a dedicated outlet
for the FreeJet.
NOTE: Do NOT connect the USB computer cable to the
FreeJET at this point, you will connect it after installing the Epson 2880
driver.
C. Fill the Bulk Ink Bottles/Getting Ready to Print
