3
Mounting
3.1
DIN rail mounting
Proceed as follows to mount
TICRO 100
to a 35 mm DIN rail (acc. to EN 50022):
1. Place the DIN rail clip supplied on delivery to the rear side of
TICRO 100
as shown in the figure
below and align it with the mounting holes. The spring side of the DIN rail clip must point towards
the DC power input socket!
2. Use the two M3x12 screws to fasten the DIN rail clip to
TICRO 100
(TX10 screwdriver required).
Do not use other screws than delivered with the DIN rail clip!
3. Hook the spring side of the DIN rail clip to the top side of the DIN rail.
4. Press the device downwards and then towards the DIN rail until the clip audibly snaps onto the
DIN rail.
Proceed as follows to remove
TICRO 100
from the DIN rail:
1. Compress the spring of the DIN rail clip by pressing
TICRO 100
downwards.
2. Release the bottom side of the clip from the DIN rail and withdraw
TICRO 100
upwards.
DC power input socket
DIN rail clip with screws
TICRO 100 Quick Start Guide
14
OMICRON
