2.2
LEDs on the front side
LED
Description
S1 and S2
Green and red LED indicating the general device status according to the following
code.
S1 (green)
S2 (red)
Meaning
off
off
TICRO 100
not is supplied with power or device reboot is
requested.
off
on
Device is booting (normal boot process after applying
supply voltage or after reboot).
on
off
TICRO 100
is ready for operation (boot process finished
and device is operational). Observe the other LEDs for
information about the PTP clock status, the status of the
Ethernet connection and the output states.
on
on
Device is booting in recovery mode. Intermediate state
when initiating a factory reset (see "Operating procedures
performed directly on the device" in the TICRO 100 User
Manual).
blinking
off
Device is in recovery mode, waiting for new software. In
the recovery mode, the device provides only a rudimentary
Web Interface just allowing for the upload of a software
image.
off
blinking
Software update is in progress.
NOTICE
Equipment damage possible.
►
Do not disconnect
TICRO 100
from the power
supply or from the Ethernet or USB connection
during a software update.
blinking
blinking
Hardware error.
RJ45 and FIBER Green LEDs to indicate the currently active Ethernet port:
RJ45 for 10/100Base-TX (twisted-pair) or FIBER for 100Base-FX (optical fiber).
Only one Ethernet port can be used at a time. The Ethernet port actually
used has to be selected in the Web Interface (see "Network Configuration
page" in the TICRO 100 User Manual).
LEDs on the
Ethernet
connectors
The green LED indicates the Ethernet connection status (link status). The yellow
LED indicates that data traffic is active on the interface.
TICRO 100 Quick Start Guide
8
OMICRON
