26 |
M 5 7 5 1
To create a new alarm, click the plus icon
and a new alarm will be added. To remove an alarm once it is
created, select the alarm in question on the left side of the alarm panel and click the delete icon
.
6 Pairing a Sensing Device to a Layer N Gateway
Refer to either the Wired or Wireless instructions to pair a Layer N Smart Probe & Interface to a Layer N Gateway.
Before continuing to the pairing instructions, ensure the following prerequisites are met:
•
Ensure that the Layer N Gateway has been properly setup, powered on, and in close physical proximity.
•
(
For Wired pairing
) Ensure the user has access to a PC and the internal Gateway UI (
refer to the Layer N Gateway
manual for instructions on how to access the internal Gateway U
I).
6.1
Wireless Pairing
Pairing a wireless Smart Interface (IF-006) with probe attached is made easy with a one-button pairing system
between the IF-006 and the Layer N Gateway.
Step 1:
When the Smart Probe and relevant accessories have been securely connected to the IF-006, push the
pairing button once on the IF-006. The LED status indicator will blink green indicating the device is in
Pairing Mode.
Step 2:
Quickly push the pairing button on the Layer N Gateway. The LED on the Gateway will blink green indicating
the Gateway is in Pairing Mode.
When the IF-006 or Smart Sensor has been successfully paired to the Layer N Gateway, the LED will stop blinking on
both devices. Readings for the newly added device will then appear on the Layer Cloud or OEG interface.
6.2
Wired Pairing
Wired Smart Probes connected directly to a Layer N Gateway with an IF-001 cable or IF-002 will need to be added to
the Gateway Internal User Interface.
The
Connected Devices
tab is the default page set once you are signed in to the internal gateway UI. From here, you
can add devices to your gateway to have them appear in your Layer N Cloud account.
Figure 33: Gateway Internal User Interface
To add a device to your gateway from the internal gateway web UI, begin by clicking the
button at the top
right of the web page. Fill out the Add Device menu with the parameters of the Smart Probe connection.